V4 Submersible Pump Set

• International NEMA spline coupling.
• Thrust Bearing used with resigns impregnated carbon v/s SS segments to ensure thrust load.
• Impeller & Diffusers are used with glass filled engineering polymer with stainless steel wear rings.
• Specially design for low voltage application.
• Rotors are dynamically balance to minimise noise & vibration.
• Pump & motors are in fully stainless steel design.
• Rotor are painted with special epoxy paint for long life.
• All sleeves are hard chrome plated to ensure the long life in sandy condition.
• All the pumps are supply with guide bush at suction end along with sand protection.
• NRV provided for reduce the back flow.

• Domestic water supply.
• Industrial.
• Agriculture.
• Solar pumping system.
• Fountains, Garden.

Motor                                                                                                     Pump

Motor Shaft : Stainless steel AISI 410 / AISI 431                                                     Impeller & Diffuser : Glass Filled engineered polymer.
Casting Part : Cast Iron FG 200 grade.                                                                    Pump Shaft : Fully Stainless Steel AISI 410
Thrust Bearing : Carbon v/s stainless steel                                                              Suction Housing : Cast Iron FG 200 grade with leaded bronze guide bush.
Stamping : Silicon steel.                                                                                         NRV : Cast Iron FG 200
Copper : E.C. grade (99.9%)                                                                                    Sleeve : AISI 410 with hard chrome platting

• Head Range : 4 to 302 meter
• Discharge Range : 10 to 450 LPM
• Motor Rating : 0.5HP to 5.0HP in Single Phase -230V, 50Hz, AC Supply
                        0.5HP to 7.5HP in Three Phase - 380V / 415V, 50Hz, AC Supply
• Voltage Range : 150V to 250V (1 Phase)
                           200V to 440V (3 Phase)

Download V4 Submersible Pump details

Download